Equipment covered under the Federal Energy Policy Act of 1992 (EPACT) shall have no minimum efficiency requirements for operation at minimum capacity or other than standard rating conditions.Equipment used to provide water heating functions as part of a combination system shall satisfy all stated requirements for the appropriate space heating or cooling category.Ī.
Table 6.8.lA-Air Conditioners and Condensing Unitsĭ. Table 6.8.1E-Fumaces, Duct Furnaces, and Unit Heaters Table 6.8.10-Packaged Terminal and Room Air Conditioners and Heat PumpsĮ. Table 6.8.1 G-Reat Rejection Equipment All furnaces with input ratings ofz65 kW, including electric furnaces, that are not located within the conditioned space shall have jacket losses not exceeding 0.75% of the input ratingĦ.4.1.2 Minimum Equipment Efficiencies-Listed Equipment-Nonstandard Conditions. Water-cooled centrifugal water-chilling packages that are not designed for operation at ARI Standard 550/590 test conditions shall have a minimum full-load COP and a minimum NPLV rating as shown in the tables 6.8.1H, 6.8.1I and 6.8.1.J.Ī. Centrifugal chillers <528 kW shall meet the minimum full-load COP and IPLV/NPLY in Table 6.8.1H. Centrifugal chillers z528 kW and <1055 kW shall meet the minimum full-load COP and IPLY /NPLV in Table 6.8.1I.Ĭ. Centrifugal chillers zl055 kW shall meet the minimum full-load COP and IPLV/NPLY in Table 6.8.l1.Ħ.4.1.3 Equipment Not Listed. Equipment not listed in the tables referenced in Sections 6.4.1.1 and 6.4.1.2 may be used.Ħ.4.1.4 Verification of Equipment Efficiencies. Equipment efficiency information supplied by manufacturers shall be verified.Ħ.4.1.5.1 Mechanical Equipment. Mechanical equipment that is not covered by the U.S. National Appliance Energy Conservation Act (NAECA) of 1987 shall carry a permanent label installed by the manufacturer stating that the equipment complies with the requirements of Standard 90.1.Ħ.4.1.5.2 Packaged Terminal Air Conditioners. Packaged terminal air conditioners and heat pumps with sleeve sizes less than 0.4 m high and 1.0 m wide shall be factory labeled.Ħ.4.2 Load Calculations.
0 kommentar(er)
